#IGNITION KEY CHIP BYPASS FOR FREE#
#IGNITION KEY CHIP BYPASS HOW TO#

If you cannot turn the key, return to the locksmith or local hardware store and ask them to verify that the new key pattern is matching the original. You may need to lightly brush off the sharp edges. Newly cut keys may not engage easily inside the ignition cylinder at first. Verify that the key was cut and programmed properly by starting the vehicle. As a last resort, ask to speak to the manager.

#IGNITION KEY CHIP BYPASS FOR FREE#

Get the new blank key blade cut at your local hardware store or locksmith to match the master key.В It will cost you around $ 2-5, and some places may even cut it for free as a courtesy since you are bringing your own key.В Some stores may refuse to cut the key because you didnвЂ™t buy it from them and therefore they вЂњcannot guarantee it will workвЂќ.В In that case just tell them that you already had it programmed, that you only need it cut, and that you will take full responsibility if it doesnвЂ™t work. You can also watch me using this technique to program a spare key for my 2005 Scion tC here:

If it didnвЂ™t work, repeat the same steps from the beginning.

And finally, verify that your new key is able to deactivate anti-theft system: security indicator light on the information display should disappear when inserting properly programmed key into the ignition cylinder.

Remove new key from the ignition cylinder.

When security light goes out, your new key is successfully programmed.

Watch security light blinking for about 60 seconds.

Verify that security light on the information display is solid, indicating that the car successfully entered programming mode.

Remove the master key from ignition cylinder.

Open and close driverвЂ™s side door 6 times.

On the 5th time leave the master key in the ignition cylinder

Insert master Scion tC key in and out of ignition cylinder 4 times.

The following programming technique doesnвЂ™t require the new key to be cut. Most sellers wonвЂ™t refund your purchase if you cut the key blade. That way you still might be able to return it, if you accidentally ordered the wrong key, if the key was incompatible, or if security chip was defective. DonвЂ™t Do This !!!Д«efore you cut the new key blade, first try to program the security chip inside the key. Also, always check compatibility at the top of the page or in the item descriptionВ area before placing the order. Make sure to buy the one with the 4D67 transponder chip and remote buttons, not just the key shell. I ordered a couple of these blank chip keys here (this is Amazon affiliated link) for around $20 a piece. Get A Blank Chip KeyДЄfter youвЂ™ve verified that you can enter the programming mode, youвЂ™ll need to buy a new key. You can exit programming mode by simply opening driverвЂ™s side door or by depressing the brake pedal. Once you verified you can successfully enter programming mode using your master key, proceed to Step 2. You can only use your master key to make duplicate keys, therefore you wonвЂ™t be able to enter programming mode using the valet key. Test Programming Mode FirstД«efore you buy a new key, verify that you are able to enter the programming mode as described in Step 3 (#1-5) below. In this article, I will share exactly how I was able to program transponder ignition chip key and remote fob for my Scion tC without any special equipment or computer software. Fortunately, there is an easy way to do it.

#IGNITION KEY CHIP BYPASS HOW TO#

One of the keys for my 2005 Scion tC literally fell apart, so I decided to find out how to make a duplicate key without breaking the bank. DIY Programming Technique For Scion tC Chip Key

Ignition key chip bypass